When the stereo is completely removed from the vehicle, clean off the dash area where the stereo was mounted and replace the trim board. Carefully disconnect these connections and carefully remove the stereo while keeping an eye out for any small screws or mounting brackets that may still be in place. Depending on the type of stereo being removed, there are usually two to three different connections. Once the trim board is removed, you can then access the stereo and it’s connections. Remove the screws holding the trim board in place using the appropriate screwdriver. This typically includes the stereo and the speaker cutouts for the vehicle. After the power is disconnected, locate the trim board around the stereo. This is typically done by removing the car’s battery and disconnecting the negative cable.
These include a pry tool, screwdrivers, and any adaptors you may need depending on your particular vehicle’s make and model.īegin by disconnecting the power to the car stereo. Before beginning the removal process, it is important to make sure you have all of the necessary tools and materials. Removing a Pioneer car stereo is a relatively easy process and can usually be completed in a short amount of time. You can then press the CLK button again to stop the clock from flashing and the time should be set. When the text “RDS” appears on the display, it means the clock has updated with the correct time. Use the seek arrows to search for a radio station that broadcasts time data.
Pioneer super tuner 2 update#
If the time does not update, press the TP button to manually update the clock. The tuner will then automatically receive time data from the radio station and set the clock accordingly. Next, press the RDS/EON button until the “EON” text appears, which means the tuner is in search mode. First, press the CLK button and make sure the clock is flashing on the display. To set the clock on a Pioneer Super Tuner III D, you’ll need to use the buttons labeled CLK, TP, and RDS/EON.
0 kommentar(er)
